Installation Guide

ManualsBrandsAndersen ManualsDoors & Windows32 in. x 80 in. 3000 Series White Right-Hand Self-Storing Easy Install Aluminum Storm Door with Brass Hardware

HANG HINGED

STORM DOOR

AND REMOVE

CLIPS

(Right Hand)

For a Left Hand Installation, go to Page 4.

Tools needed:

1/2”

1”

1 1/2”

2”

1 1/2”

5/8”

1”

x 20

1/8”

1/2”

1”

1 1/2”

2”

1 1/2”

5/8”

#10

#12

3/4” Machine Pan Painted

1/2” SMS Pan

1/2” SMS Pan Painted

1/2” SMS Flathead

1/2” Self-Drill Pan

1/2” Self-Drill Pan Painted

3/4” Machine Flathead

7/8” Machine Pan Painted

1” SMS Pan

1” SMS Pan Painted

1” Machine Pan Painted

1-1/2” Machine Flathead

2” SMS Pan Painted

5/8” SMS Pan Painted

1-1/4” SMS Pan

1. While holding door in position, use 1/8” drill bit

from closer kit to drill a hole in the mounting

surface through two pre-drilled holes (indicated

above with extra-large green arrows).

2. Fasten door to mounting surface using two 1”

screws.

3. Pre-drill holes in mounting surface through

remaining ten holes in side rails, then fasten

door to mounting surface using ten 1” screws.

4. Unlatch upper and lower handle side spacer

clips by pulling tab toward you.

1. Remove two handle hole

fasteners by inserting Phillips

screwdriver into handle hole

and rmly pressing them

out. Properly discard orange

handle fasteners.

2. Grasp edge of door and rmly

pull door open.

1. Using 1/8” drill bit, drill holes

in door jamb through holes in

hinge rail.

2. Fasten hinge rail to door jamb

using eight 1” screws. Do not

overtighten screws.

1. Grasp handle clip (F) and

pull away from latch rail to

remove.

2. Fill holes in latch rail with

color matched plugs

included in closer kit.

1. Remove spacer clips (G) by loosening but not removing screws.

2. Re-tighten screws. TIP: Use a screw driver to loosen and tighten screws;

a drill may strip the screw holes. If screws do strip, replace them with

1/2” painted screws included in closer kit (O).

3. Remove bottom spacer (H) by pressing down on raised lip.

4. Properly discard all orange clips.

1. Set bottom of door centered in opening. Make sure

orange bottom spacer (H) is sitting on door sill.

2. Tip top of door into opening while ensuring bottom

of door frame rests on orange spacer. TIP: Place foot

against door bottom while tipping top of door frame

assembly into opening.

3. Door frame assembly is properly seated in opening

when both latch rail and hinge rail are ush against

mounting surface, while hinge rail and bottom spacer

are resting on door sill. NOTE: The gap between top of

door and rain cap is intentionally uneven at this step.

Do not open door by pulling on the

handle holes. Injury could result.

WARNING

VIEW

3/16” Plug

x 2

NO 1