Installation Guide

15
TROUBLESHOOTING
(Right Hand)
For additional help with these,
or any other installation steps,
please call our Solution Center
at 1-800-933-3626.
16
If your bottom spacer falls o or is out of
position prior to fastening the door the the
mounting surface:
1. Hook the clip on to the sweep
2. Rotate clip until it snaps over back of sweep.
3. Slide clip until it is touching sweep screw on
handle side of door.
If handle binds or doesn’t spring back:
1. Slightly loosen key cylinder and lockcase
plate screws (A).
2. Test handle set. If handle moves freely,
you’re done.
3. If it still binds: Slightly loosen trim plate
screws (B).
4. If it still binds again: Slightly loosen lock
case screws (C).
If door isn’t latching onto latch rail:
1. Remove screw cover from latch rail (if
installed).
2. Remove six 1” screws from latch rail.
3. Push latch rail toward door frame until latch
falls into opening in latch rail.
4. If you can see holes in mounting surface
through holes in latch rail, you will need
to drill new holes in latch rail. Use 1/8” drill
bit to drill holes 1” above or below existing
holes.
5. Fasten latch rail to mounting surface using
six 1” screws.
6. Reinstall screw cover (see step 12c).
b
ca
!
!
1/2”
1/2”
1/2”
1”
1 1/2”
2”
1 1/2”
5/8”
5/8”
1/8”
!
!
1/2”
1/2”
1/2”
1”
1 1/2”
2”
1 1/2”
5/8”
5/8”
Tools needed:
H
X
X
X
X
X
X
X
XX
VIEW
B
A
C