Installation Guide

ManualsBrandsAndersen ManualsKitchen3000 Series 36 in. White Fullview Etched Glass Easy Install Storm Door

2. INSTALLATION PREPARATION:

In this step, you will conﬁ rm your storm door hinges on

the correct side.

Conﬁ rm your storm door hinges correctly by using

your measurements from step 1 and comparing your

door to ﬁ gures 5 and 6.

Position the door on a protected surface so the

exterior side of the door is facing up.

TIP: Lay on door carton.

Starting at the mitered corners, remove clear

protective tape from bottom of door, and the bottom 3”

of the sides.

Place decorative trim plate onto the door frame and

align the edge of decorative trim plate with latch side

edge of door frame. (Figure 7)

Fasten decorative trim plate to door frame using three

#8 x 1/2” self drilling screws (included in the closer

kit).

Remove door from carton

NOTE: when lifting the door, support the weight of the

door by the door frame, not the hinge and latch rails.

Remove the tape holding the insect screen to the door

frame.

Remove the insect screen by tilting it back and then

lifting it away from the shipping clip (Figure 8).

Remove and properly discard the shipping clip.

(Figure 8A)

With door standing, ensure latch rail is properly seated

in the orange spacer clips (Figure 8B), and ensure

bottom spacer is attached to the bottom of the door

and is slid toward the handle side. (Figure 8C)

NOTE: See troubleshooting section at the end of the

install guide if bottom spacer becomes detached from

the door frame.

10.

Figure 7

In this step, you will be removing the screen and shipping

clip, and ensuring all installation clips are in their

proper locations.

RIGHT HANDED

LEFT HANDED

EXTERIOR

VIEWS

Figure 5 Figure 6

If your door came with a decorative trim plate, you will

attach it to the exterior of your door in this step.

NOTE: Some models include an optional decorative

trim plate for the bottom exterior of the door. If your

door includes this decorative trim plate and you wish

to attach it, complete steps 2-5 below. If not, skip to

step 6.

Tools needed:

3 - #8x1/2”

Grasp Here

Figure 8