Installation Guide

3
2. INSTALLATION PREPARATION:
In this step, you will remove the insect screen and shipping clip.
Lay the door at on a protected surface with the exterior side down.
TIP: Lay on door carton.
Remove insect screen by pressing down on the shipping clip to
release insect screen (Figure 5).
Remove the shipping clip using a pair of pliers. Grasp shipping clip
and pull out of door frame. Properly dispose of shipping clip.
Reach under the side of the door frame near the handle holes and
gently push up on the glass panel until you are able to rmly grasp
onto it (Figure 6).
While maintaining a rm grip on the glass panel, gently lay the door
frame back down. Pull the glass panel away from the opposite side
of the door frame and then lift it out of door frame and set aside.
Stand the glass panel on its edge to prevent damage to it.
Left Hinged (Figure 7) - From the exterior, a left hinged storm door
will have the hinge rail on the left side of the storm door. Refer
to the illustrations in the column on the left side of the installation
guide under this heading:
Right Hinged (Figure 8) - From the exterior, a right hinged storm
door will have the hinge rail on the right side of the storm door.
Refer to the illustrations in the column on the right side of the
installation guide under this heading:
1.
2.
3.
4.
5.
6.
7.
8.
Figure 6
Figure 5
In this step, you will remove the glass panel.
In this step, you will determine the side your storm door will hinge on.
Figure 7
Figure 8
LEFT hINGE
RIGhT hINGE
INTERIOR SIDE UP
EXTERIOR
VIEWS
Remember, any mis-cuts during your storm door installation can be
replaced free of charge. Just call our Solution Center at
1-800-933-3626.
2
14
14
2
10
2
4
CARTON
INTERIOR SIDE UP
Tools needed: