Instructions / Assembly

5. Apply Head Installation Flange/Head Flashing
• Position Head Installation Flange/Head Flashing in
groove on Head Jamb, overlapping Side Installation
Flanges to the exterior. Place wood block against short
leg of Head Installation Flange/Head Flashing and tap
until fully seated.
• For Sidelight Installation Instructions proceed to Page
14 of Panel Assembly and Installation Guide #0005309.
Head
Installation
Flange/Head
Flashing
Side
Installation
Flange
Head Installation Flange/Head Flashing must overlap
Side Installation Flanges to the exterior to help
prevent water infiltration.
Interior Edge
of Head Jamb
4. Attach Head Installation Flange to Head Flashing
Standard Installation
Masonry/Concrete - Replacement Installation*
• Position Head Installation Flange groove over Head
Flashing lip. Flush ends and snap into place.
• Score and snap long leg off Head Installation Flange,
using a sharp utility knife,
• Position modified Head Installation Flange groove over
Head Flashing lip. Flush ends and snap into place.
Head Installation Flange
Head
Flashing
Flush
at Ends
* For installations where flanges are not being used.
Handle aluminum Head Flashing with care to
avoid bending.
Head
Flashing
Modified Head
Installation Flange
Head
Installation
Flange
Long Leg
Score
Line
Standard Installation
Masonry/Concrete - Replacement Installation
Groove
Lip
Flush
at Ends
Groove
Lip
Ends and edges of Head Flashing are sharp. Use
caution when handling Head Flashing. Failure to do
so may result in personal injury.
Exterior Side Up
Frame Assembly and Installation Guide
7