User Manual

28
000XXXX
1) Make sure the screen is properly installed
and red screen sensor is depressed.
2) Make sure the control panel is set to the ON
position.
3) Check to make sure driver arms are
attached to sash.
4) Make sure the control panel, driver and
remote are all adequately powered:
- Control panel switch is set to ON position
- All wires are plugged in.
- Check wiring diagram and conrm wire
connections.
5) Check window and driver for obstruction:
- Weatherstripping
- Debris
- Sash misalignment
- Power operator misalignment
6) Conrm driver is correctly programmed to
the control panel and/or remote.
7) Check for moisture on the rain sensors.
Initiate rain senor override if needed.
8) Make sure driver is installed on a window
within the correct weight limit.
9) Make sure window is unlocked.
10) Check Low Battery indicator, replace
battery if necessary.
11) Check 10 Amp fuse on red wire to battery
conection. Located in control panel box.
Power driver Does
Not Operate - Open
or Close
Power driver Does
Not Oper
ate - Open
or Close
Issue/ Issue Things To Check / Things To Check
See: Power Operator Does Not Operate Or
Close Section
1) Check for short/break in wiring. Make sure
everything is properly grounded.
2) Make sure screen is properly installed and
screen sensor is depressed
Power Operator Has
Intermittent Opening/
Closing
Power Operator Has
Inter
mittent Opening/
Closing
1) Make sure the screen is properly installed
and red screen sensor is depressed.
2) Make sure the control panel is set to the ON
position.
3) Check to make sure driver arms are
attached to sash.
4) Make sure the control panel, driver and
remote are all adequately powered:
- Control panel switch is set to ON position
- All wires are plugged in.
- Check wiring diagram and conrm wire
connections.
5) Check window and driver for obstruction:
- Weatherstripping
- Debris
- Sash misalignment
- Power operator misalignment
6) Conrm driver is correctly programmed to
the control panel and/or remote.
7) Check for moisture on the rain sensors.
Initiate rain senor override if needed.
8) Make sure driver is installed on a window
within the correct weight limit.
9) Make sure window is unlocked.
10) Check Low Battery indicator, replace
battery if necessary.
11) Check 10 Amp fuse on red wire to battery
conection. Located in control panel box.
See: Power Operator Does Not Operate Or
Close Section
1) Check for short/break in wiring. Make sure
everything is properly grounded.
2) Make sure screen is properly installed and
screen sensor is depressed
Power Window Control System Trouble Shooting
Power Window Control System Trouble Shooting