User Manual

30
000XXXX
Issue/ Issue Things To Check / Things To Check
Check instuction guide for proper override
procedure
1) Override duration is one hour, further
overrides will have to be initiated manually
Rain Sensor
Override Is Not
Working
Rain Sensor
Over
ride Is Not
Working
1) Check cleanliness of both rain sensors
- Use rag to remove debris from sensor(s)
2) Inspect both rain sensors for signs of
damage
3) Rain sensors will only work if override has
not been initiated, see instruction guide for
override procedure
4) Rain sensors will only work when droplets of
water physically come into contact with sensor.
Rain Sensor Is Not
Working when rain or
moisture is present
Rain Sensor Is Not
W
orking when rain or
moisture is present
1. Push reset button on console and reprogram
all windows as desired. Refer to
progamming process for further instruction
How Do I Reset The
Console When
Adding Additional
Windows?
How Do I Reset The
Console When
Adding Additional
W
indows?
1) Make sure driver is secured correctly with
supplied hardware to both frame and sash
rod.
- Inadequte torquing of screws will limit the
space for cover to be snapped into place.
Make sure all screws are properly secured
but NOT over torqued.
2) Check for obstruction
- Verify screen sensor is not depressed by
cover
- Verify the tabs on the front of the driver
housing are located properly
- Verify the driver is centered on the sill
- Verify that screws are seated in predrilled
holes in frame
3) Validate the sill cover length matches the
window unit width.
Sill Cover will not
attach to driver
Sill Cover will not
attach to driver
Check instuction guide for proper override
procedure
1) Override duration is one hour, further
overrides will have to be initiated manually
1) Check cleanliness of both rain sensors
- Use rag to remove debris from sensor(s)
2) Inspect both rain sensors for signs of
damage
3) Rain sensors will only work if override has
not been initiated, see instruction guide for
override procedure
4) Rain sensors will only work when droplets of
water physically come into contact with sensor.
1. Push reset button on console and reprogram
all windows as desired. Refer to
progamming process for further instruction
1) Make sure driver is secured correctly with
supplied hardware to both frame and sash
rod.
- Inadequte torquing of screws will limit the
space for cover to be snapped into place.
Make sure all screws are properly secured
but NOT over torqued.
2) Check for obstruction
- Verify screen sensor is not depressed by
cover
- Verify the tabs on the front of the driver
housing are located properly
- Verify the driver is centered on the sill
- Verify that screws are seated in predrilled
holes in frame
3) Validate the sill cover length matches the
window unit width.
Trouble Shooting Continued/