User's Guide

Battery Replacement Instructions
When a low battery is detected in a wireless sensor, a low
battery message will display on your keypad when properly
configured with your security system.
Tools Needed for Battery Replacement:
The tools needed are dependent upon the product in
which the batteries are being replaced.
• Safety glasses • Flashlight
• Small needle nose pliers • Phillips screwdriver
• Small at head screwdriver
Casement and Awning Windows
1. Move the window lock lever(s) from the lower locked
position to the center position. The sash can be
opened or closed.
2. Remove the lock bezel using a small at head
screwdriver, taking care not to scratch the wood or
lock bezel (right-hand lock for awning windows).
Removal of the lock lever is not necessary.
3. Below the lock lever in the lock bezel opening, locate
the battery tray tab. Due to the recessed location of
this tab, the use of a flashlight may be necessary to
illuminate the work area.
4. Using a small needle nose pliers, carefully pull on the
tab to remove the battery tray.
5. Remove the discharged batteries (see battery disposal
information on page 5).
6. Replace the batteries with two fresh CR-1632 lithium
coin cell batteries. Take care to properly position the
“+” terminals of both batteries to correspond with the
“+” marking on the battery tray for proper battery
polarity.
7. Again using a small needle nose pliers, insert the
battery tray making sure the arrow on the face of
When replacing the battery, do not touch any of
the circuitry on the sensor. Static from your
body could damage the sensor.
Batteries are small parts and, if swallowed, could
pose a choking hazard to young children.
the battery tray is facing upward. Continue to fully
push the battery tray in. The battery tray will
encounter several points of light resistance as the
batteries contact the sensor.
8. Verify the proper battery polarity by observing the
L.E.D. light illumination during the battery
insertion. If the L.E.D. does not illuminate, check
to make sure Steps 6 and 7 were followed
correctly and insert the battery tray in sensor.
9. Replace the lock bezel.
10. Close and lock the window unit.
11. Verify that the sensor is communicating with the
security control panel by unlocking the window
and checking the keypad for the window unlock
message and then opening the window and
checking the keypad for the window open
message. See page 4 for verification instructions.
Casement and Awning Windows
Side
Jamb
Lock
Lever
Battery
Tray
Lock
Bezel
Arrow Up
Arrow
Lock
Lever
Battery
Tray Tab
Battery Tray
Interior View
User’s Guide
6