2BSST POWER AMPLIFIER OWNER’S MANUAL
IMPORTANT SAFETY INSTRUCTIONS The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of un-insulated “dangerous voltage “ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.
2BSST TWO CHANNEL POWER AMPLIFIER INTRODUCTION: Thank you for choosing the Bryston 2BSST. We welcome any suggestions you may have, or comments regarding the operation of your amplifier. We consider you, our customer, to be Bryston’s’ most important resource, and your opinion is very much appreciated. No warranty card is necessary to initiate your coverage. Refer to the back page for detailed warranty information. Please save the original box and all packing materials.
2BSST TWO CHANNEL POWER AMPLIFIER REMOTE POWER CONTROL ~ 12 VOLT TRIGGER CONNECTOR: The 2BSST may be powered on or off using a 12 volt A/C or D/C voltage by using the rear panel 4 position screw terminal connector. Insert the 12 volt wires into the input labeled ‘IN’ (polarity is not important). The power amplifier will now power on when a 12 volt trigger voltage is applied or off when removed.
2BSST TWO CHANNEL POWER AMPLIFIER 2Bsst SPECIFICATIONS: Power Output: 100 watts per channel into 8 ohms Input Impedance: 10K ohms single ended (unbalanced) 15K ohms double ended (balanced) Sensitivity: 2v setting 2 Volts in = 100 Watts into 8 ohms - gain 23 dB 1v setting 1 Volt in = 100 Watts into 8 ohms - gain 29 dB Distortion: THD+noise: < 0.010% 20Hz to 20kHz at 100 watts into 8 ohms, IMD: < 0.
2BSST TWO CHANNEL POWER AMPLIFIER 4
2BSST TWO CHANNEL POWER AMPLIFIER 5
There are no user serviceable parts inside the 2Bsst. Please refer any servicing to qualified personnel.
