Instructions / Assembly

Swivel Barstool Assembly Models: B24, B30, B124-24
Sunset Trading is happy to answer any assembly questions and replace missing parts. We appreciate your business and our main
concern is your convenience and happiness. Thank you for your purchase and we look forward to serving you as our lifelong
customer! We hope you enjoy your new stools! The Sunset Trading Team
Before you begin:
• Check to be sure that you have all parts and
hardware
• Place all wooden pieces on a clean and smooth
surface like a carpet to avoid parts being
scratched
• Do not tighten all screws/ bolts until completely
assembled
• Swivel plate top and bottom needs to be turned
at 90-degree angles prior to installation. If not
pre-turned, place swivel plates on your floor,
use packaging carton to protect the surface,
step on swivel to twist using your body weight
• If missing parts or have questions, please email
[e-mail] anytime or call Sunset
Trading 877-364-8464, M-F 8am-4pm EST.
Step 1. Place swivel on
base with ‘TOP FRONT’ markings on swivel facing
upward. Attach swivel to base using four (4) #10
Philips screws and four (4) flat washers. Tighten
with a #10 Philips screwdriver (Not Provided).
Step 2. Place seat upside
down on table or bench (lay a towel down to
protect from scratches) or on the edge of mattress.
*IMPORTANT: Make note of marking on top of
swivel that reads ‘TOP FRONT’. This side of the
swivel must be mounted toward the front of the
barstool seat in order to provide proper angle for
sitting.
Parts
QTY
Top Seat Unit
(Pre-Assembled)
1
Base
(Pre-Assembled)
1
Swivel Plate
1
Seat Machine
Bolts
4
Lock Washers
4
Flat Washers
8
#10 Philips
Screws
4
4mm Allen
Wrench
1
Flip base upside down and place on top of Seat Unit
bottom. Line up the four (4) slots in the swivel top with
the four (4) nut inserts that are mounted in the seat.
Step 3. Put one (1) Lock Washer and one (1) Flat
Washer on each Seat Machine Bolt. Attach the swivel to
the seat bottom through the access hole in the bottom
of the base Unit with all four (4) bolts.
Step 4. Screw all 4 bolts in half way with Allen wrench
provided. Turning base unit as needed to access the
nuts that are inserted on the barstool seat. Tighten all
bolts fully when done. Assembly is complete!
Bottom of base
Bottom of seat