User Manual

Apply the Cuff
a. Pull the cuff end through the metal loop, positioning it outward
(away from your body).
Body Posture
Sitting During Measurement
a. Be seated with your feet flat on the floor without crossing your legs.
b. Place your hand palm-side up in front of you on a flat surface such as a desk or table.
c. The middle of the cuff should be at the level of the right atrium of your heart.
MEASUREMENT PROCEDURES
5 6
b. Place a bare arm through the cuff and position the cuff
1/2”(1-2cm) above the elbow joint.
c. Tighten the cuff and close it by pulling it towards your
body, securing it closed with the Velcro fastener.
d. While seated, place your hand palm-side up in front of you on a flat surface such as a desk
or table. Position the monitor in the middle of your arm aligned with your middle finger.
Remember to:
1. Make sure that the appropriate cuff size is used; refer to the cuff circumference range in
“SPECIFICATIONS”.
2. Measure on the same arm each time.
3. Stay still during measurement. Do not move your arm, body, or the monitor.
4. Stay still and calm for one to one and half minutes before taking a blood pressure
measurement.
5. Keep the cuff clean. Cleaning the cuff after every 200 times of usage is recommended.
If the cuff becomes dirty, clean it with a moistened cloth. Do not rinse the monitor or cuff
with running water.
Lying Down During Measurement
a. Lie on your back.
b. Place your arm straight along your side with your hand palm-side up.
c. The cuff should be placed at the same level as your heart.
Note: Blood pressure can be affected by the position of the cuff and your physiologic condition.
During measurement, press the “START/STOP” button for 2 seconds to turn off the monitor
manually.
1/2”(1-2cm)
ON/OFF
i
H
e
a
l
t
h
e. The cuff should fit comfortably, yet snugly around your arm. You should be able to insert one
finger between your arm and the cuff.