Integration Instructions

8. INTEGRATION INSTRUCTIONS
List of applicable FCC rules
Complies with part 15.225
Summarize the specific operational use conditions
This device should be installed and operated with minimum 20 cm between the radiator and your body. The module
must not be co-located or operating in conjunction with any other antenna or transmitter.
Limited module procedures
Not applicable
Trace antenna designs
Not applicable
RF exposure considerations
This module complies with FCC/IC RF radiation exposure limits set forth for an uncontrolled environment. The
module is limited to installation in mobile or fixed applications. At least 20 Cm of separation distance between the
transmitting antenna and the user’s body must be maintained at all times.
The host manual shall include the RF exposure statements.
Antennas
The antenna is permanently attached to the module.
Antenna type: PCB pattern antenna
Label and compliance information
The module is labeled with its own FCC. If the FCC ID/IC is not visible when the module is installed inside another
device, then the outside of the device into which the module is installed must also display a label referring to the
enclosed module. In that case, the final end product must be labeled in a visible area with the following:
“Contains FCC ID: 2A28FAORDR”,
Information on test modes and additional testing requirements
This module is tested in a standalone. Co-location of this module with other transmitters that operate simultaneously
are required to be evaluated using the FCC multi-transmitter procedures.
Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter rules) listed on the
grant, and that the host product manufacturer is responsible for compliance to any other FCC rules that apply to the
host not covered by the modular transmitter grant of certification.
The host product may need to be evaluated against the FCC Part 15B criteria for unintentional radiators in order to
be properly authorized for operation as a Part 15 digital device.
- FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This device should be installed and operated with minimum 20 cm between the radiator and your body.