Installation & Assembly

Installation Instructions

CEILING

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing compliantNEC

junction boxes.

This product is safety listed for damp locations.

Incandescent version may be dimmed with a standard incandescent

dimmer. version may be dimmed with a dimmer. ConsultLED LED

lamp manufacturer for additional information.

This instruction shows a typical installation.

CAUTION RISK OF FIRE-

This product must be installed in accordance with the applicable

installation code by a person familiar with the construction and

operation of the product and the hazards involved.

Use minimum 90°c supply conductors.

SAVETHESE INSTRUCTIONS!

PAGE 1
Installation Instructions CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. CEILING Use minimum 90°c supply conductors. GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is safety listed for damp locations. Incandescent version may be dimmed with a standard incandescent dimmer.
PAGE 2
Install the Fixture 1A JUNCTION BOX 4 3 MOUNTING PLATE 1 MOUNTING STUD FIXTURE BASE CAP NUT 5 6 SOCKET ASSEMBLY LAMP THREADED PIPE HEX NUT 7 SHADE WASHER WASHER 8 WASHER WASHER HEX NUT LOWER CAP FINIAL 9 1 Secure the mounting plate to the junction box. 2 Connect the fixture to a suitable ground in accordance to local electrical codes. 3 Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.