Owner's Manual

Page 6
To Set-up your Spindeck
Install the Drive Belt
1. Remove the brown paper insert that supported the platter during transport.
2. Install the drive belt around the top section of the pulley, as shown in the following
illustration.
3. Put the felt mat on the top of the platter.
Connect Spindeck to your Amplier
Spindeck has a captive tonearm signal lead (pg.5, #12) for connection to the amplier.
Use the Phono input on your amplier or Spinbase.
The plug with the red band should be attached to the RIGHT channel input jack, and the
plug with the white band is the LEFT channel.
The third individual wire is a GROUND wire. Connect this to the ground screw on
Spinbase or compatible amplier. If your amplier does not have a ground screw, slip
it under one of the screws which hold the amplier chassis together and tighten it
securely. Leaving this wire unattached will result in excessive hum.
Note: The phono input you use must be suitable for use with a magnetic cartridge. Line
inputs (such as Aux, CD, Tuner, Tape or Video) are not suitable. If your amplier does
not have a suitable Phono input you will need a separate phono preamplier stage for
magnetic cartridges. This will be connected between the Spindeck and a free line level
input of the amplier.
Belt set for 33 RPM as shown