Chocolate fountain Please read the manual fully before using the appliance and keep the manual safe for future reference.
Contents Important safeguards Page 3 Appliance components parts Page 4 Before first use Page 5 Using the correct chocolate Page 5 Using your chocolate fountain Page 6 Enhancing presentation Page 7 Cleaning Page 7 Troubleshooting Page 8 BS Plug information Page 9 UK and EU Guarantee Page 10 Disposal of the appliance Page 11 2
Important safeguards When using any electrical appliance, basic safety precautions should always be followed including: This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
position where it can be pulled on by children or animals or be tripped over. Always operate the appliance on a smooth, even and stable surface. Do not place the unit on a hot surface. Always remove the plug of the appliance safely. Do not pull on the appliances cord to remove the appliance plug from the electrical socket. Never handle or operate the appliance with wet hands. Appliance specific safety instructions Do not assemble the auger or tower while the motor is running.
Before first use: 1. Unpack from the box and poly bags. 2. Remove the tower and auger from the base. 3. Using a damp, non-abrasive cloth, wipe the tower, auger and motor base. 4. Stand the motor base on a level surface. 5. Place the auger onto the triangular shaped auger support in the centre of the motor unit. 6. Place the tower over the auger until the holes at the base of the tower are aligned with the supports on the heating basin of the motor base. The tower should stand sturdy and level.
Using your Chocolate Fountain Now that you have selected your chocolate, follow these instructions to begin: 1. Place the unit on a stable work surface ensuring it is level. It is important for the unit to be level to create the desired flowing effect. 2. Plug the unit in. Make sure that your unit works by testing the motor function to see that the auger turns and that the heater works. Once this is done, turn both off. 3. Melt 680g of chocolate chips or chocolate cut into chunks.
Enhancing presentation Enhance the presentation of your chocolate fountain with “Liquor flavoured chocolates”. Prior to mixing the liquor with the chocolate, you can burn off the alcohol of the liquor by cooking it on the stove top. By bringing it to the boil it burns off the alcohol, leaving only the flavour. Mix this with your choice of chocolate before adding it to the Chocolate fountain.
Troubleshooting Problem Possible Cause/ Remedy Chocolate is too thick, thin with vegetable oil. Unit is not level. Adjust the feet at the base of the motor unit until the Chocolate Fountain is level. Chocolate is flowing but unevenly Chocolate is flowing unevenly, but not sheeting Unit is not level. Level unit so that chocolate is evenly distributed around the tower to ensure proper sheeting. Adjust the feet at the base of the motor unit until the Chocolate Fountain is level.
Electrical information Please note: It is extremely important that the wires or cores in the flex are connected to the correct terminals in the plug. If the colour of the mains lead of the appliance does not correspond with the coloured markings identifying the terminals in your plug proceed as follows: The Live (Brown) wire connects to the rightmost live (L) terminal nearest to the fuse. The Neutral (Blue) wire connects to the leftmost neutral (N) terminal.
If a moulded plug is fitted and has to be removed take great care in disposing of the plug and severed cable, it must be destroyed to prevent it from engaging into a socket. If the supply cord is damaged it must be replaced by a service agent or a similarly qualified person in order to avoid a hazard. All of our electrical appliances conform to pre-existing EC Directives 2006/95/EC (Low Voltage Directive) and 2004/108/EC (EMC Directives). For further information please visit http://www.esc.org.
All of our prices are inclusive of VAT. Once a product has been returned to us, we will aim to repair or replace it within 30 days of receipt. The guarantee does not cover any defect arising from improper use, damage, buildup of lime scale or repair attempts made by third-parties. Also, the guarantee does not cover normal wear and tear of individual parts.