Owner manual

8
5. Fit the boom of the table clamp to the
boom of the middle pole underneath the
table at the height you wish the table to be
and ghten using the screw on the clamp
(you can adjust this once the appliance has
been assembled). Place the table through
the extender tube onto the middle tube so
that it rests on the boom table clamp.
6. Screw the middle pole with the table onto
the boom pole.
7. Feed the electrical cord through the base of
the appliance so that it runs through the
middle tube and extender tube, leaving
adequate length to aach the head of the
appliance.
8. Lay the appliance at and aach the
electrical cord to the head of the appliance.
Place the head of the appliance into the
extender tube and pull the cord at the base
of the appliance to create some tension in
the electrical cord. Be careful not to pull the
lead too ght as this will disconnect the
appliance.