User's Manual

These processes should be completed in roughly two minutes. If this process fails, login to the WLS as above
and type the command ./stop_reboot. If all indications are correct, proceed to Step 10.
Step 10.
At the # prompt enter the command: start The program will go through a series of
initializations and when the screen reads started watchdog, hit the enter key and a #
prompt will appear.
Step 11.
At the # prompt enter the command: ./stop_reboot This will stop the unit from
rebooting if the unit does not see a network connection.
Step 12.
At the # prompt enter the command: ./stop_processes .
Step 13
. Type pwd on the command line.
Step 14.
Hit enter to determine the directory structure, this should be /ram/bpu/tester.
Step 15.
At the command line type: testCtrl This will bring up the TESTCTRL Main Menu.
Step 16.
Select 2 Backplane Control menu. This is the area where tests from the backplane are run.
Test LED’s on the front panel
Step 1.
Select 3 to test Alarm LED.
Step 2.
Select 1 to turn on the LED. ( the LED should illuminate)
Step 3.
Select 3 to test Alarm LED.
Step 4.
Select 0 to turn off the LED. (the LED turn off)
Step 5.
Select 4 to test Active LED.
Step 6.
Select 1 to turn on the LED. ( the LED should illuminate)
Step 7.
Select 0 to turn off the LED. (the LED turn off)
Step 8.
Select 5 to test Online LED.
Step 9.
Select 1 to turn on the LED. ( the LED should illuminate)
Step 10.
Select 0 to turn off the LED. (the LED turn off)
Confirm Status Word
Step 1.
Select 1 to read Status Word. Status Word should read as follows: