User's Manual

User’s Manual for Node C Network Elements
Page 12
M0121A1A_uc.doc
2.3 QUICK START CHECKLIST
Read the health and safety warnings in chapter 1.2 Health and Safety Warnings.
Setting up the Node C is quick and easy. The following step-by-step procedure
provides a quick overview for a correct setup and optimization.
a. Required Equipment
Node C
donor antenna
coverage antenna(s) or DAS
coaxial feeder cable
connectors
laptop with connection and mains cable
b. Required Information
Make sure to have the following information at hand:
important on-site conditions (e.g. base station location, mains supply, etc.)
channels to be enhanced/amplified
pilot
pilot power to total power
c. Procedure
1. Install the donor and coverage antennas.
2. Install the feeder cable from the Node C to the antennas.
3. Install the Node C (see chapter 3 Installation).
4. Install the Interface Unit (see chapter 3 Installation).
5. Connect cables between the Interface Unit and the Node C (see chapter
3.2 Electrical Installation).
6. Connect power and the antenna feeder cables to the Node C.
7. Open the Interface Unit as described in chapter 4.1 General.
8. Setup the connection computer (see chapter 4.2 Software Setup) and
establish a connection to the Node C (see chapter 4.2.3 Connection
Procedures).
9. Login to the unit and follow the installation wizard option for easy
installation.
a. Optimize the donor antenna performance (see chapter 4.2.4.1
Setup Wizard).
b. Select the channels for enhancement.
c. Enter the desired output power in the downlink.
d. Enter the pilot power to total power ratio of the donor base
station.
e. Enter the relative uplink gain.
f. Setup the modem (if applicable) and enter data in the other user
fields.
10. The Node C setup is complete.
11. Open the “Save Configuration to Laptop” menu for record keeping
purposes.
12. Unplug the computer, close the Interface Unit and tighten all screws.