User's Manual

User’s Manual for Node C Network Elements
Page 84
M0121A1A_uc.doc
À Check the communication mode between the modem and the terminal. The
following parameters should be set for a GSM modem.
Bit rate / bit per second: 9600 baud Number of data bit: 8 bit
Parity bit: No parity Stop bit: 1 stop bit
These settings may only be changed locally. Should a different modem be used, the
operator should ensure that the settings are changed prior to leaving the site.
5.4.1.1 Initstrings
The initialization string depends on the operator’s network and the modem. It may be
necessary to adjust the init string in the field. The following init string is factory set.
Modem Network Initstring
not yet available t.b.d.
via Node C Web Interface:
t.b.d.
table 5-2 Standard initstring for modem
5.4.1.2 Wireless Modem
The wireless modem allows remote
control and maintenance of the Node C.
Parameters may be changed; alarm and
measurement statistics may be
acknowledged and collected in the
OMC.
The modem is installed in the cover of
the Interface Unit. The antenna
connector for the modem is located at
the connector panel of the Interface Unit
For technical data of the modem refer to
chapter 7.2.3 Specifications for Optional
Equipment.