Installation Guide

M0201AKC CommScope Era
™
High Power Carrier Access Point Installation Guide — Preliminary
© April 2019 CommScope, Inc. Page 13
CAP H Overview
OCTIS Kits
All CAP H units include one OCTIS
1
Kit for the primary interface to a Classic CAN or TEN that CAP H plugs into
the CAP H Optical Port 1. You can order an additional OCTIS K
it, which would allow you to cascade two
CAP Hs via Optical Port 2, or to attach an auxiliary Ethernet device via
the AUX Port. Table 4 identifies the
OCTIS Kit options.
CAP H cascading using Optical Port 2 is not supported by the current software version but is planned for
a future software version. Auxiliary Ethernet devices are not supported by the current software version.
Table 4. CAP H OCTIS Kits
Kit Name
CommScope
PN
Description
Optical OCTIS Kit 7770612 Use as follows:
• Optical Port 1—to connect th
e CAP H to a Classic
CAN or TEN.
• Optical Port 2—to cascade a second CAP H. (N
ot
supported by current software.)
• Ships with the following grommets:
– 6mm nominal diameter for use with cables
with
OD range from 4.8-5.8
– 7mm nominal diameter for use with cables
with
OD range from 5.8-6.8
– 8mm nominal diameter for use with cables
with OD range from 6.8-7.8
Ethernet OCTIS Kit 7760652 Use to attach an auxiliary Ethernet device.
Fiber/Cable
Protective Kit f. OCTIS
7823597 Use to protect fibers or cables; is 2m (78.7”) long.
1 OCTIS is a trademark of RADIALL.