Installation Guide

CommScope Era
™
High Power Carrier Access Point Installation Guide M0201AKC
Page 14 © April 2019 CommScope, Inc.
Safely Working with a CAP H
SAFELY WORKING WITH A CAP H
The following sections provide important information that you should read and know before working with
the CAP H. Observe all cautions and warnings listed in this section and el
sewhere in this installation guide.
RF Safety Cautions
This system is a RF Transmitter and continuously emits RF energy. Maintain a minimum clearance from
the antenna as specified in Table 6 while the system is operating. When
ever possible, power down the
CAP H
before servicing the antenna.
Only license holders for the respective frequency range are allowed to operate this unit.
Do not operate the CAP H without terminating the antenna connectors. The antenna connectors may be
terminated by connecting them to their respective antennas or to a dummy load.
Health and Safety Precautions
Electrical hazard. Danger of death or fatal injury from electrical current. Obey all general and regional
installation and safety regulations relating to work on high voltage installations, as well as regulations
covering correct use of tools and personal protective equipment.
Laser radiation. Risk of eye injury in operation. Do not stare into the laser beam; do not view the laser
beam directly or with optical instruments.
High frequency radiation in operation. Risk of health hazards associated with radiation from the
antenna(s) connected to the unit. Implement prevention measures to avoid the possibility of close
proximity to the antenna(s) while in operation.
Risk of injury by the considerable weight of the unit falling. Ensure there is adequate manpower to handle
the weight of the system.
Risk of serious personal injury by equipment falling due to improper installation. The installer must verify
the following.
• There is adequate manpower to han
dle the weight of the system during installation.
• That the supporting surface will safely
support the combined load of the electronic equipment and all
attached hardware and components.
• When wall mounting a CAP H, the wall anchors (screws and anchors) used to mount the CAP H should
be appropriate for the
wall structure/material.