Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Era System Overview
- CAP H Overview
- Safely Working with a CAP H
- Installing a CAP H
- Using the Status LED to Determine State of the CAP H
- Maintenance
- Contacting CommScope
CommScope Era
™
High Power Carrier Access Point Installation Guide M0201AKC
Page 28 © April 2019 CommScope, Inc.
Installing a CAP H
Pole Mounting a CAP H
This procedure tells you how to mount the CAP H to a wall using the Pole Mounting Kit (CommScope Part
Number 7661538).
It is the responsibility of the installer to verify that the pole will safely support the combined load of the
electronic equipment and all attached hardware and components and to ensure that the CAP H
is safely
and securely mounted.
The maximum diameter of the pole or column cannot exceed 120 mm (4.7 inch).
Maximum of
120 mm (4.7”)