Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- Era System Overview
- CAP H Overview
- Safely Working with a CAP H
- Installing a CAP H
- Using the Status LED to Determine State of the CAP H
- Maintenance
- Contacting CommScope
M0201AKC CommScope Era
™
High Power Carrier Access Point Installation Guide — Preliminary
© April 2019 CommScope, Inc. Page 29
Installing a CAP H
1 Mark the position of where the screw bands should be attached to the pole, as shown in the following
graphic, which also shows the pole-mounting pitches.
Minimum:
775 mm
(30.51”)
Maximum
788 mm
(31”)