Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- ERA System Overview
- CAP H Overview
- Safely Working with a CAP H
- Installing a CAP H
- Using the Status LED to Determine State of the CAP H
- Maintenance
- Contacting CommScope
M0201AKG_uc CommScope ERA
®
High Power Carrier Access Point Installation Guide
© February 2021 CommScope, Inc. Page 31
Installing a CAP H
2 Drill four holes (two holes per bracket) at the positions marked in Step 1.
3 Insert anchors in each of the holes drilled in Step 2.
4 Mount the brackets (A) to the wall using the M8x20 screws (B), split-lock washers (C) and flat washers
(D) so that the flat washers are against the mounting bracket:
The anchors are not included with the CAP H shipment as the suitable type depends on the wall material).
Anchors should be used for all wall mountings, except for when mounting to a wooden wall.
A
B
C
D