Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- ERA System Overview
- CAP H Overview
- Safely Working with a CAP H
- Installing a CAP H
- Using the Status LED to Determine State of the CAP H
- Maintenance
- Contacting CommScope
CommScope ERA
®
High Power Carrier Access Point Installation Guide M0201AKG_uc
Page 32 © February 2021 CommScope, Inc.
Installing a CAP H
5 Do the following to mount the CAP H in the Wall Mount Bracket.
a Hang the CAP H in the upper bracket.
b Push the CAP H into to the lower bracket (A), and then fasten it to the lower bracket using two M8x20
screws (B), split-lock washers (C) and flat washers (D) so that the flat washers are against the
mounting bracket; torque to 27 N-m.
A
B
D
C