Installation Guide
Table Of Contents
- Table of Contents
- Document Overview
- ERA System Overview
- CAP H Overview
- Safely Working with a CAP H
- Installing a CAP H
- Using the Status LED to Determine State of the CAP H
- Maintenance
- Contacting CommScope
M0201AKG_uc CommScope ERA
®
High Power Carrier Access Point Installation Guide
© February 2021 CommScope, Inc. Page 43
Installing a CAP H
Assemble the Antenna Cable Connector
The graphics in this section illustrate how to assemble the antenna cable connector and do not show the
CAP H.
1 Gather the following tools:
• Torque wrench
• Adjustable counter wrench.
2 Join the connectors and turn the coupling nut until the thread
grips.
3 Push in the connector until it clicks.
4 Fasten the coupling nut hand-tight. Do not turn the connector but
the coupling nut only.
5 Retain the cable connector with the counter wrench (A) and fasten
the coupling nut with the torque wrench (B) until the torque is
applied (torque wrench clicks).
Note that for angled antenna connectors you should use your
hand to retain the cable connector and fasten the coupling nut
with the torque wrench. Make sure only the coupling nut is
turned, not the cable connector.