Installation Guide

M0201AKG_uc CommScope ERA
®
High Power Carrier Access Point Installation Guide
© February 2021 CommScope, Inc. Page 53
Maintenance
MAINTENANCE
Maintenance of the CAP H and replacement of components should only be performed as described in this
section.
For most maintenance procedures, appropriate tools are required to ensure correct handling. All of these
tools can be ordered from the supplier.
Unless otherwise agreed to in writing by CommScope, CommScope's general limited product warranty
(http://www.commscope.com/Resources/Warranties/) shall be the warranty governing the CAP H,
including its installation, maintenance, usage and operation.
Rules to Observe During Maintenance
Adhere to all cautions and warnings listed in the following sections:
• "RF Safety Cautions" on page 18
• "Health and Safety Precautions" on page 18
• "Property Damage Warnings" on page 19
• "Guard Against Damage from Electro-Static Discharge" on page 19
• "General Installation Safety Requirements" on page 20
• "Installation Cautions" on page 26.
The unit reaches high temperature in operation. Risk of burns by hot surface. Do not touch the unit before
it has sufficiently cooled down.
Disconnect the CAP H from mains power before starting any maintenance.
To maintain the warranty, avoid unintentional damage to the seals on the modules.
If a CAP H must be returned to CommScope or your local sales office, use appropriate packaging. Use of
the original packaging for shipping the unit is strongly recommended.
Defective parts should only be replaced by original parts from the supplier. All service work performed
inside the housing is performed at the users own risk.
Due to the CAP H design, the Fan Unit is the only component that should be replaced in the field. Contact
the supplier for replacement of any other components.