User's Manual Part 1
M0201AA ION
®
-E Series Hardware Installation Guide
© June 2017 CommScope, Inc. Page 23
WCS-2 and WCS-4 Subracks and Modules
Auxiliary Unit Transport Card (AUT)
TheAUTCardprovidesa1Gbpass-throughconnectionbetweentheCAN/TENandtheUAPforWiFi,IP
cameras,orother1GbEthernetdevices.YouinstallanAUTCardinSlotM1orM2oftheWCS-2orWCS-4
Subrack.
UNRESOLVED: The RJ45 ports are reversed top (5 - 6) vs. bottom (1 - 4). Are the LEDs the same regardless
of vertical orientation of plug, or are the LEDs also reversed (top left is bottom right)?
UNRESOLVED: If the Right LED is green, to know if it means 100 Mbit/s vs. not connected, to be not
connected, wouldn’t the Left LED be off?
UNRESOLVED: Confirm Gbps can replace Gbit/s and Mbps = Mbit/s
For information on the internal mapping between CAT Cards and AUT Cards, go to "Connect the AUT
Cards” on page 32.
AUT Card LEDs
Ref # LED LED Color Description
2Left LED
on RJ45 Ports 1 - 8
• Off • No activity on that port.
• Flashing green • Activity on that port.
Right LED
on RJ45 Ports 1 - 8
• Off • Port is transmitting 1 Gbps.
• Green • Port is transmitting 100 Mbps or is not connected (
Left LED will be off).
3 STATUS • Off • Error on the AUT Card, or AUT Card is not receiving power.
•Green •AUT Card functioning as expected.
• Red • AUT Card is experiencing an error.
AUT Card Connectors
Ref # Component Device Function
1 Ports 1 - 8 RJ45 ports Connects the CAN/TEN to WiFi, IP Camera, or other 1Gb
Ethernet devices; provides the 1Gb pass-through connection
between the CAN/TEN and the UAP.
1
1 Unless otherwise noted, the use of “UAP” collectively refers to the UAP, UAP-X, UAP-N25, and the CAP L.
1
2
3
2