User's Manual Part 1

ION
®
-E Series Hardware Installation Guide M0201AA
Page 56 © June 2017 CommScope, Inc.
Installing UAPs
7 InsertandtightenthefourM5X10
machinescrewstosecurethe
mountingbracketandshroudtothe
UAP.
8 Ifgroundingisrequired,attachan
appropriategroundwiretotheUAP’s
greengroundingscrew.
9 Tightenthetwomountingbracket
thumbscrews,andthentightenthe
lockingnutstosecurethethumbscrews.
10 CarefullyplacethemountedUAPintotheceilinggridandmakesurethatthesupport-barclipsare
attachedtotheceilinggrid.
11 ConnecttheCat6AcablestotheMainandAUXportsoftheUAP.
Grounding is not mandatory.
UAPs are classified as low-voltage
devices and do not have internal
power supplies. However,
CommScope recommends you
check local and national electrical
codes to determine if grounding is
a requirement for the location in
which you are installing the UAP.
Always lift the UAP by the support bar or the face of the unit. Do not lift the UAP by holding the edge of
the ceiling tile.
Mounng
screws
Grounding
stud (green)
Mounng
screws
4 M5 x 10 screws
Support-Bar clips
Thumbscrews
Locking nuts