User's Manual Part 2

M0201AA ION

-E Series Hardware Installation Guide

Identifying CAP Ls in the ION-E Software

CAP L with a Copper Interface and Power Cat 6A Cable

Connectors

REF # Label Description Function

1, 4 ANT 3, ANT 4 Not available; connector is plugged.

2ANT 1

4.3-10 RF connector

RF connectors that connect to two separate external antennas or to two ports on a

cross-polarized dual antenna via 50Ω coaxial cable. Each connector supports two RF

bands as described in Table 7-2 on page 77. The end of the 50Ω coaxial cable that

connects to an ANT connector can be either a push-pull or a threaded connector. If not

used, an ANT connector must be plugged.

3ANT 2

6 Unlabeled Pushbutton switch Turns power to CAP L on/off. Power to the CAP L may also be shutdown via the ION-E

Series Software. [

verify can power off via GUI]

CAUTION! Prior to disconnecting the Power cable from the CAP L, press the

Power button to power off the CAP L.

7 Unlabeled 36 to 60 Vdc Power connector Plugged, not applicable to this model configuration.

8 2 Port 2 Plugged, not applicable to this model configuration.

9 1 Port 1 Port 1 connects to an ION-E CAN/TEN via CAT 6A cable and provides the main signal

and power interface.

10 A RJ-45 connector The AUX port provides a cascade connection to an optional locally powered secondary

CAP L, or provides a connection to external Ethernet devices such as WiFi and IP

cameras. Cabling is via the appropriate CAT cable for the protocol; this model supports

an 1000 BASE-T and 802.3at Class 3 Power over Cat6A Ethernet connection. Maximum

attached cable length is 3 meters (9.8 feet). The AUX port must be plugged if not in use.

Power LED (unlabeled)

Ref # LED Color Description

5 • Blue • CAP L is powered on and operational.

• Flashing blue • CAP L is powered on and initializing.

• Off • CAP L is not powered on.

For further information, see "Powering a CAP L” on page 82.