User's Manual

ManualsBrandsAndrew Wireless System ManualsElectronicsOptical Remote Unit ION-M85P R EP

Table Of Contents

Installation Instruction

The Remote Unit, Extension Unit or Master Unit has to be

mounted by proffessionel / special trained installer.

1.1. MECHANICAL INSTALLATION

1.1.1. General

Read the health and safety warnings in section 1.3.

1. Do not install the unit in a way or at a place where the specifications outlined in the Environmental

and Safety Specifications leaflet of the manufacturer are not met.

2. It is strongly recommended to install the unit vertically.

3. When mounting the Remote Unit, the connector flange (illustrated in chapter Fehler! Verweisquelle

konnte nicht gefunden werden. Fehler! Verweisquelle konnte nicht gefunden werden.) with the

cables must point to the ground. A maximum tilt angle of 25° to the horizontal position of the

connector flange must be kept in each mounting direction. For details, refer to chapter Fehler!

Verweisquelle konnte nicht gefunden werden. Fehler! Verweisquelle konnte nicht gefunden

werden.. If a different installation of the Remote Unit is required, please contact customer service for

further information.

4. It is recommended to use the mounting hardware delivered by the manufacturer only. If different

mounting hardware is used, the specifications for stationary use of the Remote Unit must not be

exceeded.

 Note: Exceeding the specified load limits may cause the loss of warranty!

5. The unit is considerably heavy. Make sure that a suitable mounting surface is used. Ensure there is

adequate manpower to handle the weight of the system.

Summary of content (6 pages)

PAGE 1
Installation Instruction The Remote Unit, Extension Unit or Master Unit has to be mounted by proffessionel / special trained installer. 1.1. MECHANICAL INSTALLATION 1.1.1. General Read the health and safety warnings in section 1.3. 1. Do not install the unit in a way or at a place where the specifications outlined in the Environmental and Safety Specifications leaflet of the manufacturer are not met. 2. It is strongly recommended to install the unit vertically. 3.
PAGE 2
6. Due to power dissipation, the Remote Unit may reach a very high temperature. Ensure sufficient airflow for ventilation. A minimum distance of 300 mm to ceiling, floor, etc. must be maintained above and below the unit. Also, observe the instructions in the individual mounting procedures. 7. For outdoor installations, the pre-mounted front cover must be installed. 8. For indoor installations where the ambient temperature can reach above 40°C, the cover must be removed. 9.
PAGE 3
1.2. ELECTRICAL INSTALLATION 1.2.1. General Read the health and safety warnings in section 1.3. 1. This unit contains dangerous voltages. Loss of life, severe personal injury, or property damage can be the result if the instructions contained in this manual are not followed. 2. It is compulsory to ground (earth) the unit before connecting the power supply. A grounding bolt is provided on the cabinet to connect the ground-bonding cable. 3.
PAGE 4
1.3. HEALTH AND SAFETY WARNINGS 1. Only suitably qualified personnel are allowed to work on this unit and only after becoming familiar with all safety notices, installation, operation and maintenance procedures contained in this manual. 2. Read and obey all the warning labels attached to the unit. Make sure that the warning labels are kept in a legible condition and replace any missing or damaged labels. 3.
PAGE 5
8. Note for a Class A digital device or peripheral: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
PAGE 6
Equipment Symbols Used Please observe the meanings of the following symbols used in our equipment: Symbol Compliance Meaning --- Alert sign to R&TTE Symbol Indicates conformity with the R&TTE directive 1999/5/EC certified by the notified body no. 0700.