Installation Instruction

ManualsBrandsAndrew Wireless System ManualsElectronicsION-B Remote Unit for cellular systems

The Remote Unit, Extension Unit or Master Unit has to be

mounted by proffessionel / special trained installer.

1.1. TFAX CASE U MECHANICAL INSTALLATION

1.1.1. General

Read the health and safety warnings in chapter 1.3.

1. Warning: Do not install the unit in a way or at a place where the specifications

outlined in the Environmental and Safety Specifications leaflet of the supplier are not

met.

2. WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING

CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT. The installer

must verify that the supporting surface will safely support the combined load of the

electronic equipment and all attached hardware and components. The screws and

dowels (wall anchors) used should also be appropriate for the structure of the

supporting wall.

3. Warning: It is recommended to use the mounting hardware delivered by the

manufacturer only. If different mounting hardware is used, the specifications for

stationary use of the Remote Unit must not be exceeded.

4.  Note: Exceeding the specified load limits may cause the loss of warranty!

5. Warning: The unit is considerably heavy. Ensure there is adequate manpower to

handle the weight of the system.

6. Caution: Due to power dissipation, the Remote Unit may reach a very high

temperature. Ensure sufficient airflow for ventilation.

7. Note: When connecting and mounting the cables (RF, optical, mains, ...) ensure that

no water can penetrate into the unit through these cables.

8. Note: Observe all additional rules or restrictions regarding mounting that apply to

specific Remote Unit types.

If any different or additional mounting material is used, ensure that the mounting remains as safe as the

mounting designed by the manufacturer. Ensure that the static and dynamic strengths are adequate for

the environmental conditions of the site. The mounting itself must not vibrate, swing or move in any

way that might cause damage to the Remote Unit.

Specified torques must be observed for certain mounting procedures according to the following table:

Type Pins Hex nuts Screws

Thread

M 6 M 6 M6

Specified torques

3.3 Nm 3.3 Nm 3.3 Nm

Summary of content (5 pages)

PAGE 1
Installation Instruction The Remote Unit, Extension Unit or Master Unit has to be mounted by proffessionel / special trained installer. 1.1. TFAX CASE U MECHANICAL INSTALLATION 1.1.1. General Read the health and safety warnings in chapter 1.3. 1. Warning: Do not install the unit in a way or at a place where the specifications outlined in the Environmental and Safety Specifications leaflet of the supplier are not met. 2.
PAGE 2
1.2. TFAX CASE U ELECTRICAL INSTALLATION 1.2.1. General Read the health and safety warnings in chapter 1.3. 1. Warning: This unit contains dangerous voltages. Loss of life, severe personal injury, or property damage can be the result if the instructions contained in this manual are not followed. 2. Caution: It is compulsory to ground (earth) the unit before connecting the power supply. A grounding bolt is provided on the cabinet to connect the ground-bonding cable. 3.
PAGE 3
13. Caution: Observe the labels on the front panels before connecting or disconnecting any cables. 1.3. HEALTH AND SAFETY WARNINGS 1. Danger: Obey all general and regional installation and safety regulations relating to work on high voltage installations, as well as regulations covering correct use of tools and personal protective equipment. 2. Danger: Before opening the unit, disconnect mains power. 3.
PAGE 4
12. Warning: For installations, which have to comply with FCC RF exposure requirements, the antenna selection and installation must be completed in a way to ensure compliance with those FCC requirements.
PAGE 5
19. Note: For a Class A digital device or peripheral: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.