Installation Instruction

ManualsBrandsAndrew Wireless System ManualsElectronicsION-U Remote Unit for cellular systems

The Remote Unit, Extension Unit or Master Unit has to be

mounted by proffessionel / special trained installer.

1.1. MECHANICAL INSTALLATION

1.1.1. Health and Safety for Mechanical Installation

Read and observe chapter 1.3 Health and Safety

1. Caution: Risk of injury by the considerable weight of the unit falling. Ensure there is

adequate manpower to handle the weight of the system.

2. Caution: Risk of serious personal injury by equipment falling due to improper installation.

The installer must verify that the supporting surface will safely support the combined load

of the electronic equipment and all attached hardware and components. The screws and

dowels (wall anchors) used should also be appropriate for the structure of the supporting

wall.

1.1.2. Property Damage Warnings for mechanical installation

1. Attention: Do not install the unit in a way or at a place where the specifications outlined in

the Environmental and Safety Specifications leaflet of the supplier are not met.

2. Attention: Due to power dissipation, the Remote Unit may reach a very high temperature.

Ensure sufficient airflow for ventilation.

3. Notice: Exceeding the specified load limits may cause the loss of warranty.

4. Notice: When connecting and mounting the cables (RF, optical, mains, ...) ensure that no

water can penetrate into the unit through these cables.

5. Notice: Ensure that there is free access to the electrical connections as well as to the

cabinet. The approved bending radius of the connected cables must not be exceeded.

6. Notice: If any different or additional mounting material is used, ensure that the mounting

remains as safe as the mounting designed by the manufacturer. The specifications for

stationary use of the Remote Unit must not be exceeded. Ensure that the static and

dynamic strengths are adequate for the environmental conditions of the site. The mounting

itself must not vibrate, swing or move in any way that might cause damage to the Remote

Unit.

Summary of content (8 pages)

PAGE 1
Installation Instruction The Remote Unit, Extension Unit or Master Unit has to be mounted by proffessionel / special trained installer. 1.1. MECHANICAL INSTALLATION 1.1.1. Health and Safety for Mechanical Installation Read and observe chapter 1.3 Health and Safety 1. Caution: Risk of injury by the considerable weight of the unit falling. Ensure there is adequate manpower to handle the weight of the system. 2. Caution: Risk of serious personal injury by equipment falling due to improper installation.
PAGE 2
7. Notice: Observe all additional rules or restrictions regarding mounting that apply to specific Remote Unit types. For details refer to the mechanical specifications in the data sheet for the unit. Install the unit vertically with the fan unit at the top. A maximum tilt angle of 25° from a vertical position must be maintained, as shown in the following illustrations: 8. Notice: A spacing of 40 mm (1.58 inch) around the unit is required. 9.
PAGE 3
1.2. ELECTRICAL INSTALLATION 1.2.1. Health and Safety for Electrical Installation Read and observe chapter 1.3 Health and Safety 1. Danger: Electrical hazard. Danger of death or fatal injury from electrical current. Obey all general and regional installation and safety regulations relating to work on high voltage installations, as well as regulations covering correct use of tools and personal protective equipment. 1.2.2. Property Damage Warnings for electrical installation 1.
PAGE 4
10. Notice: For unstabilized electric networks, which frequently generate spikes, the use of a voltage limiting device is advised. 11. Notice: Observe the labels on the front panels before connecting or disconnecting any cables. 12. Notice: Unused connectors must be closed with their protective covers to ensure watertightness.
PAGE 5
1.3. HEALTH AND SAFETY WARNINGS 1. Danger: Electrical hazard. Danger of death or fatal injury from electrical current. Obey all general and regional installation and safety regulations relating to work on high voltage installations, as well as regulations covering correct use of tools and personal protective equipment. 2. Caution: Laser radiation. Risk of eye injury in operation. Do not stare into the beam; do not view it directly or with optical instruments. 3.
PAGE 6
8. Notice: Only license holders for the respective frequency range are allowed to operate this unit. 9. Notice: Make sure the repeater settings are correct for the intended use (refer to the manufacturer product information) and regulatory requirements are met. Do not carry out any modifications or fit any spare parts, which are not sold or recommended by the manufacturer. 1.5. COMPLIANCE 1.
PAGE 7
4. Notice: For installations which have to comply with FCC/Industry Canada requirements: English: This device complies with FCC Part 15 and Industry Canada license exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This device complies with Health Canada’s Safety Code.
PAGE 8
7. Note: For a Class A digital device or peripheral: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.