Corporation User Guide Antennas ATC200-Lite
ATC200-Lite Teletilt
®
Remote Control Downtilt System Section 7–Changing the Electrical Downtilt-Group
Bulletin 639510 May 2005 7-3
6. After the devices are moved to the ‘Antennas Included In Move’ box, examine the group to
ensure that the group does not include any antennas that are not desired for this move.
7. To remove one or more antennas from the group move, either click on that antenna and
then click ‘Remove’, or double click on that antenna to move it back to the right hand
box.
8. When satised with the list of antennas that will be included in the group move, enter a
new downtilt angle and click ‘Activate’ to start the move. Progress for each antenna move-
ment in the group will be displayed separately.
1. Enter a new electrical tilt angle.
Refer to the electrical tilt range to ensure that the new tilt angle
entered is within the tilt range for the antenna model.
Angles may be entered as whole degrees or as a combination
of whole degrees and tenths of a degree (Ex: 5.0 or 5.5).
2. Click ‘Activate’.
Figure 7-3. Entering New Electrical Tilt Setting for Sector Move.