User's Manual

385700-1006-006 OPERATIONS
Document use is restricted to that described on cover 3-1
CHAPTER 3
OPERATIONS
3.1 CONTROLS AND INDICATORS
The following paragraphs outline the controls and indicators for the MDR and BDR.
3.1.1 MDR CONTROLS AND INDICATORS
Refer to Mobile Data Radio Controls and Indicators. The power switch is on the MDR’s front
panel. With its power switch in the
ON
position, the front panel
POWER ON
indicator remains
lit. After the BDR and MDR establish communication, the MDR lights its
RECEIVER LOCK
indicator until it loses the RF signal.
3.1.2 BDR CONTROLS AND INDICATORS
Refer to Base Station Data Radio Assembly Controls and Indicators. The BDR has one
control switch,
CB1
, located on its rear panel. With this switch in the up position, the unit is
ON
. With the switch in the
ON
position, the unit lights its
POWER ON
indicator. When
CB1
is in the down position, the unit is
OFF
.
Once the BDR has established communication with an MDR, the BDR lights its
RECEIVER
LOCK
indicator until it loses the RF signal.
Before beginning transmission between
the MDR and BDR, securely connect the
RF antennas to both units. Failure to
observe these cautions can damage the
equipment.
The Base Data Radio and Mobile Data Radios are unlicensed devices
operating under the conditions of FCC part 15 regulations. This
equipment is intended to be installed and operated by professional
parties. It is the responsibility of those parties to insure that the
equipment is operated in compliance with the applicable FCC part 15
specifications.
CAUTION