User's Manual
Table Of Contents
- GENERAL MANUAL INFORMATION
- PREPARATION FOR STORAGE OR SHIPMENT
- DESCRIPTION OF EQUIPMENT
- LOCATIONS AND DESCRIPTIONS OF MAJOR COMPONENTS
- EQUIPMENT CHARACTERISTICS
- INSTALLING THE RADIO EQUIPMENT
- INTERCONNECTIONS
- CABLE AND GROUND REQUIREMENTS
- COMPONENT JACK LOCATIONS
- INITIAL PREPARATION FOR USE
- RADIO APPLICATION CODE UPGRADE
- PN SPREADING CODE SELECTION
- ANTENNA AND CABLE INSTALLATION
- CONTROLS AND INDICATORS
- STARTUP AND SHUTDOWN PRODECURES
- OUTPUT POWER SETTINGS
- ANTENNA PLACEMENT
- FUNCTIONAL DESCRIPTION OF EQUIPMENT
- PREVENTIVE MAINTENANCE, INSPECTION, AND CLEANING
- TROUBLESHOOTING
- CORRECTIVE MAINTENANCE
- TEST PROCEDURES
- MDR TESTS
- BDR TESTS
- RADIO DATA PORT TO USER SUPPLIED EQUIPMENT INTERFACE
- PARTS LIST
- BASE DATA RADIO MECHANICAL OUTLINE
- DIAGNOSTIC MENU
- MDR DIAGNOSTIC LCP MENU
- LCP COMMANDS
385700-1006-006 DIAGNOSTIC LCP MENU
Document use is restricted to that described on cover 8-2
BDR Diagnostic LCP Menu
Phase II WAYSIDE LCP MENU SW Ver #: 01.01
1 Send Poll Requests 21 A/D Select 41 Read Track
2 Set PN Index (CDMA Code) 22 Set Clock Search 42 Read AGC
3 Program Synthesizers 23 OS-9 Shell 43 Power
4 Reserved 24 Set RCS Address 44 Test EEPROM
5 Reset DSP 25 Reserved 45 Read PA/Temp
6 Reserved 26 SSR Status Request 46 Poll Response
7 Reset PN 27 System Block Status 47 Select Antenna
8 Reset PN (RX,STROBE) 28 Status Request 48 unused
9 Reserved 29 Show Poll Counters 49 unused
10 Set Upper Threshold 30 Clear Poll Counters 50 Read Memory
11 Upper Thres w/o PN Reset 31 Reserved
12 Set Lower Threshold 32 Read TRACK/AGC Values
13 Lower Thres w/o PN Reset 33 Set dBm Output Level
14 Set Lower Lock Threshold 34 Change dBm/DAC Values
15 Disable Transmitter 35 Serial EEPROM Display
16 Enable Transmitter 36 Save Current Settings
17 Load SC Register 37 Load TnD SC Register
18 Disable Test Port 38 Reserved
19 Enable Test Port 39 Toggle Temp Compensation
20 PN Test Select 40 Display System Log
Figure 8-1 BDR LCP Menu