User's Manual

385700-1006-006 DIAGNOSTIC LCP MENU
Document use is restricted to that described on cover 8-7
must save the entries to non volatile memory using the SAVE CURRENT SETTINGS
command.
SERIAL EEPROM DISPLAY BDR and MDR
This command displays the radio configuration parameters stored in the non volatile
memory of the radio. These are the parameters loaded into the radio upon applying
power to the unit.
SAVE CURRENT SETTINGS BDR and MDR
This command writes the current radio configuration parameters to the non volatile
memory of the radio.
LOAD TND SC REGISTER BDR and MDR
This command is reserved for future use or internal unit testing.
TOGGLE TEMP COMPENSATION BDR and MDR
This command is reserved for future use or internal unit testing.
DISPLAY SYSTEM LOG BDR and MDR
This command is reserved for future use or internal unit testing.
Read Track BDR and MDR
This command is reserved for future use or internal unit testing.
Read AGC BDR and MDR
This command is reserved for future use or internal unit testing.
Power BDR and MDR
This command is reserved for future use or internal unit testing.
Test EEPROM BDR and MDR
This command performs a non destructive test of the EEprom circuitry.
Read PA/Temp BDR and MDR
This command is reserved for future use or internal unit testing.
Poll Response MDR
This command toggles the MDR poll response state between enabling and disabling a
fixed command response. Enabling the fixed poll response configures the radio to
transmit an 81 byte message whenever the MDR receives a valid poll request from the
BDR.