Installation Instructions

AE02B-A3659 Rev -- APPENDIX B
Document use is restricted to that described on cover B-2
Figure B-1. Main software control screen.
The software will immediately start communicating with the amplifer if the comm port and cabling is
configured properly. A green bar displaying “connected to amplifer” will be displayed on the bottom of the
main window. If a red bar indicating “timeout on response from amplifier!” is displayed then most likely the
comm port has to be configured. This is accomplished by clicking on the Config pull down menu and
selecting the appropriate comm port. Once the software is communicating properly with the amplifier then
the channels may be programmed. This is accomplished by clicking inside the channel boxes. A Set
Channel window will open as shown in Figure B-2.