Technical data

Insert pivot blocks (P/N 205876) onto the end of the azimuth strut using lubricated 1/2 inch

bolt, ﬂatwasher and hex nut as shown in Figure 24. A 3/4 inch ﬂat washer should be inserted

between the strut and the spacer block. Tighten hardware according to the A-325 tensioning

procedure.

Slide the round strut assembly bracket (P/N 203875) on the end of the azimuth strut, and

hand tighten the 1/2 inch setscrews before mounting it on the ground mount assembly as

shown in Figure 25.

Installation Procedures

Step 6

Step 7

Figure 25

Hand Tighten the

1/2 inch Setscrews

3/4 inch

Flat Washer

Figure 24