Technical data

Loosen the clamp on the jack boot.
Unscrew the jack by using a spud wrench until the jack connects to the back of the enclosure
as shown in Figure 42.
Installation Procedures
Step 10
Step 11
Step 12
Step 13
Step 14
37
Figure 42
Tighten the hardware using the A-325 tensioning procedure.
Lubricate the jackscrews using the maintenance procedures.
Pull the protective boot over the jackscrew, and clamp it at the end as was performed
with the azimuth jackscrew.
The ground mount assembly is now completed with the necessary operational essentials.
All ground mount options (such as motors) have separate instructional bulletins
located in the parts kit that contains the option.
The next step in the installation process is the reflector assembly. Proceed to the next
section if you are installing the ES40C-1, ES40K-1, ES40CM-1, ES40KM-1 earth station
antenna.