Technical data

Note: Failure to follow an installation procedure could result in damage to equipment or
personal injury.
Additional warnings will be displayed throughout this
manual for your awareness. These warnings can be
identified in warning boxes as shown in the sample
to the right.
Andrew disclaims any liability or responsibility for the results
of improper or unsafe installation, operation or maintenance practices.
Andrew supplies all appropriate hardware/parts required for the installation of your 4.0 Meter
Earth Station Antenna. All tools necessary for the installation process should be provided by
the installation crew. Andrew recommends that the following tools be used for a proper
installation of the 4.0 Meter Earth Station Antenna.
Table 1. Recommended Tools
Tool Size Qty.
Open End Wrench 1/4“ 2
3/8“ 2
1/2“ 2
9/16” 2
5/8” 2
3/4” 2
7/8“ 2
1-1/4” 1
Drive Sockets 7/16” 2
9/16” 1
3/4” 1
7/8” 1
1-1/16” 1
1-1/4” 1
Spud Wrench 1-1/16“ 1
Breaker Bar 1/2” 1
Screw Driver Standard 1
Phillips 1
Allen Wrench 1/2“ 1
Tape Measure Standard 1
Felt-tip Marker Standard 1
Hammer Standard 1
Rubber Mallet Standard 1
Pry Bar Standard 1
Tin Snips Standard 1
Crane 1 Ton Minimum Capacity 1
Rope/Cord (2000 lb breaking strength) 50 ft 1
Shackles 5/8“ 2
Ladder 10 Foot Extension 1
Nylon Web Sling 3” x 3’ 2
Getting Started
Recommended Tools
ES40CM-1 or ES40KM-1
6
WARNING
Additional warning
information will be located
in this type of format.