User's Manual

AE04B-A0279 Rev -- APPENDIX B: SOFTWARE INSTALLATION
Document use is restricted to that described on cover B-1
APPENDIX B
SOFTWARE INSTALLATION
1. Tools required
One personal computer (PC) with Windows 95, 98, or Windows NT.
2. SMARTpc Lite Software Installation and Configuration
2.1 Overview
2.1.1 The SMARTpc software provides a means to control and monitor the SelectAmp800
series (and other Smart-equipped Andrew products) locally or from a remote site.
2.1.2 The application software runs on a PC under Windows and communicates with firmware
inside the SelectAmp800.
2.1.3 Local connections require a programming cable which is provided with the
SelectAmp800.
2.1.4 Remote connections require a PC accessible modem.
2.2 Installation/Configuration Instructions
2.2.1 Install the Software on the PC.
2.2.1.1 Insert the installation disk into floppy drive.
2.2.1.2 Run the setup.exe executable located on the installation disk.
2.2.1.3 The default installation directory is c:\smartpc, but the setup program prompts you in
order to allow a different installation directory.
2.2.1.4 After setup is completed, there should be a new program group called SMARTpc Lite.