Instruction manual

Step 5: 30 Seconds after the last button press, the Water Heater Display will go back to “User Mode”. It will read “Max
S
etpoint” without showing a temperature value if the temperature setpoint is at the maximum setting. The Water Heater
Display can be set back to the “User Mode” immediately by pressing both the “Temperature Up” and “Select” buttons
together for 3 seconds.
Display of Water Temperature:
Step 1: In Service Mode, Press the “Select” button until “Water Temp” is displayed in the upper right section of the water
heater display. For water heaters using two temperature sensors in the tank, this will be the average reading between the
two sensors. For water heaters using a single sensor, this is the reading for the sensor.
SELECT SET
S
tatus
idle
Operational
Max
S
etpoint
Exiting Service Mode
SELECT SET
Status
°
F
i
dle
O
perational
Wate
r
Temp
15
Ecoflo E864_ADENDA_MAR 2012 ignition+tempOCT12 16/10/12 11:07 Page 15