Operation Manual

andrews-sykes.com
Andrews H 60
Humidier
Operating Instructions
& Safety Guide
Getting started and operation
General Safety
Electrical Safety
0800 211 611
Humidiers are for internal use only.
This equipment should only be used by a competent
person who has read and understood these instructions.
Check condition of equipment before use. If unit is
showing any signs of damage contact your supplier
immediately.
Never operate this equipment if you are ill, feeling tired or
under the inuence of alcohol or drugs.
Do not use in wet or damp conditions.
Keep all vents and grills clear of obstructions.
Keep children and animals away from the humidifer.
Never leave them alone in a room where the units are in
use.
Make sure equipment is switched o and unplugged after
use.
This unit requires a 230 volt electrical supply and plugs into
standard domestic 13 amp socket.
Always inspect plugs and power cables for damage before
plugging into power supply.
DO NOT USE IF ANY DAMAGE IS FOUND.
Ensure cables are installed to prevent hazards.
If an extension lead is used, ensure it is of the correct standard
and fully uncoiled before use.
Cables must not be laid in wet or damp areas.
Do not move equipment while operating.
Do not pull equipment by the power lead.
It is recommended that the electrical supply to this equipment
is protected by an RCD.
Fig 3
Select required fan speed
Fig 4
Set Humidistat to required RH setting
Fig 5
Red indicator light will illuminate
when water level is low
Switch o power and unplug unit
Fig 1
Position equipment on level ground.
Connect to electrical supply
Fig 1
Fig 3
Fig 4
Fig 2
Fill with clear water
Fig 5
Fig 2