Quick Start Guide

Page 10
Step 6: Setting up your Wearable
1) The Wearable is ready to use. Please make sure someone
is near your Mobile Elite 4G Phone when testing your
Wearable.
2) Press the center of the Wearable (this is where the call
button is located) for three seconds.
3) You will feel the click of the Button when you first push it.
Hold the Button down until the green LED turns on (3
seconds) and then RELEASE it. You will see the LED at the
top of the button start to flash. A green LED flash indicates
that you are initiating a call from your Mobile Elite 4G
Phone to the call center. While the green LED is flashing,
you may cancel the call by pressing and holding the Button
for three seconds. The LED will stop flashing and the call
will be cancelled.
4) Whenever a call is initiated, the Mobile Elite 4G Phone will
announce “Dialing Call Center”. You may cancel this call by
pressing and holding the call button on the Wearable for
three seconds. The green LED will stop flashing and the
Mobile Elite 4G Phone will announce “Call Cancelled”.
5) If the call goes through, please tell the Call Center that you
are OK and that this is a test call.
6) Your Wearable is now paired and you have verified that
you are able to start a call to the call center on the
Wearable.
7) Your Wearable is water resistant, but it is not waterproof.
It can be splashed, but it should not be submerged.