Specifications

5 L20-349 R3
INSTALLATION
Install the fryer in accordance with the preceding Code
Requirements, as well as the following Installation
Requirements.
1 . DO NOT install this fryer in a mobile home,
trailer, or recreational vehicle.
2 . Install this fryer in a location that allows it to be
moved away from other adjacent appliances
for cleaning and maintenance.
NOTE: If the fryer is installed among
a row of appliances (“banked”), with
its only convenient movement forward,
sufficient room must be available in
front of the fryer to permit its separa-
tion from adjacent appliances for
cleaning and maintenance.
3 . Tightly fasten the legs (or casters) to the bot-tom of the
fryer using the supplied hardware, to prevent the fryer
from tipping, wobbling or rocking when it is in its
FRYER RESTRAINING DEVICE INSTALLATION INSTRUCTIONS
Install one restraining device connector
securely into the structure wall directly behind
the fryer’s desired location (Figure 2).
2. Install one restraining device connector on the
rear panel of the fryer very close to the quick-
disconnect device on the end of the fryer’s gas
line.
3. Attach one end of the restraining cable to the
wall connector. Attach the other end to the
fryer connector.
4. Confirm that the fryer cannot move far enough
away from the wall to cause excessive move-
ment of the flexible gas line or its associated
connectors.
5
REQUIREMENTS
desired location. Refer to the following Leg Installation
Instructions or Caster Installation Instructions for leg
or caster attachment and leveling information.
4 . Confirm that the air from the ventilation hood
flowing near the fryer after installation is
NOT
blowing on the rear of the unit, to prevent
affecting the burner flames and possibly causing
control damage.
CAUTION: Hood make-up air
MUST NOT flow in a manner that
restricts or impedes the natural flow
of combustion or ventilation ai
r
.
!
1
.
W
A
R
NIN
G
!
F
ryers MUST have a movement-limiting
(restraining cable) device installed to
p
reven
t
tipping that causes splashing or
spilling its HOT contents.
NOTE: This movement-limiting device
is to be furnished and installed by the
fryer’s installing contractor before the
fryer is connected to the gas line at its
desired location.