Specifications

6 L20-349 R3
LEG INSTALLATION INSTRUCTIONS
1 . Position the fryer on its side on a clean surface.
2. Attach each leg with four bolts, washers and nuts
(provided).
3. Tighten securely
LEG LEVELING
INSTRUCTIONS
1. Move the fryer to its desired location.
2. Turn the screw-type leg adjustment ends as
necessary to level the fryer, until NO tipping,
rocking, or wobbling is evident.
3. Perform the “Fryer Restraining Device
Installation Instructions.”
Figure 3. Typical Leg Installation
CASTER LEVELING INSTRUC-
TIONS
Move the fryer to its desired location.
Determine whether the fryer tends to wobble
or rock when in its desired location. If it
does , perform steps 3 through 9. If it does
not, skip to step 10, then proceed to the
Installation Instructions.
Determine which caster requires adjustment
and the approximate amount of change
required to level the fryer.
Position the fryer on its side, exposing the bottom
of the fryer (Figure 5).
Completely remove the bolts. Retain the bolts for
later reassembly.
Reinsert each mounting bolt through the
caster mounting plate; next, place a spacer of
the required size on the bolt before inserting
the bolt into the bottom of the fryer.
Repeat step 6 for all remaining bolts.
Tighten all four bolts with locking nuts evenly
and securely against the bottom of the fryer.
Return the fryer to its desired location.
Lock
the front casters to prevent fryer movement
and check again for wobbling or rocking.
Repeat steps 4 through 8 until no wobbl-
ing or rocking occurs. When the fryer no
longer wobbles or rocks, perform step 10.
Next, perform the “Fryer Restraining
Device Installation Instructions.”
W
A
RNIN
G
The fryer MUST NOT tip, rock or wob-
ble, to avoid splashing or spilling its HOT
shortening contents during operation.
CASTER INSTALLATION
INSTRUCTIONS
1. Postion the fryer on its side on a clean surface.
2. Attach each caster with four bolts, washers, and nuts
(provided).
3. Mount locking casters on the front of the fryer
and fixed casters on the rear.
4 . Tighten securely.
!
1.
2.
3.
4.
5.
6.
7.
8.
9.
Figure 4. Typical Caster Installation
10.