Installation Instructions

MODEL:S36
POWERBANK
1 12 23
4
7 8 9 1110
5
6
1 12 23
4
7 8 9 1110
5
6
1 12 23
4
7 8 9 1110
5
6
Switch on off : Press the button once to turn on, digital display . Press the button twice to
shut down 2 seconds later ,To press the switch on and off interval 2 seconds, digital
display light off.
Tip: When the power digital display is 0,please charge for power bank, There is battery
protection circuit to avoid damage caused by overcharging.
1.Protection: over charge, over discharge, over current, short circuit, multiple protection
2.Working temperature: In the environment of -10 to 45°C environment can work normally
3.Storage temperature: -20 to 50°C
A Small black bag
Cell type: Li-ion Polymer Cell
Capacity:10000mAh/3.7V
Input:DC 5V/2A(max)
Output:DC 5V/2A(max)
Size:86*82*25.5mm
Net weight:220G
1、 Led light
2、U SB output
3、T YPE-C input
4、M icro input
5、W ireless output position
6、P ower digital display
7、 Switch
8、U SB input
9、M icro output
10、T YPE-C output
11、F or Iphone output
Remark
Please charge for power bank in time if it doesn't respond
when pressing the button or charging for other devices.
The power bank should charge one time per 3 months at least
Warning
Do not throw the power bank into the fire to avoid danger.
Do not disassemble, open, break, bend, deform, Pierce or
invade the power bank into water. Do not try to dr y the
power bank with hair dryer, microwave oven or other
appliances to dry the power bank. Children should
use this product under the supervision of a person.
Avoid dropping the product on a hard surface
Charging for power bank
Method 1: Insert the USB cable in Figure 8 into the adapter,
and the digital display flashes to indicate is charging
Method 2: Use your own usb cable. Insert a Micro or Type-C
data cable into the corresponding port of Type-C input in
Figure 3 or Micro input in Figure 4. Insert USB into the
adapter, and the digital display flashes to indicates charging
Insert 9.10.11 in the figure into the corresponding device and
the digital display flashes to indicate is charging of other
devices.
Insert a data cable into the figure 2 USB output, and insert the
other end into the corresponding device. The digital display
flashes to indicate is charging of other devices
Charging for other devices
A
A
A