User's Manual

ADHERE STRICTLY TO THESE
AND ALL OTHER SAFETY
INSTRUCTIONS AND GUIDELINES
·
Ensure a barrel blocking device is fitted
to the ANGEL.
·
Ensure the hopper is removed from
the ANGEL.
·
Ensure that there are no paintballs
in the ANGEL.
·
Paintball industry standard eye/face/ear
and head protection designed specifically
to stop paintballs and meeting ASTM
standard F1776 (USA) or CE standard
(Europe) must be worn by user and any
person within range.
·
SHOULD YOU BE UNSURE AT ANY STAGE
YOU MUST SEEK EXPERT ADVICE.
Trigger adjustment
The trigger system has four adjustable
points: back stop, front stop, magnetic
return strength control and activation point.
When adjusting the trigger it is advisable
to set both the front and back stop positions
before you proceed to set the return
strength or activation point.
Back stop
Counter-clockwise = moves the point
at which the trigger stops - backwards,
towards the grip cheek
Clockwise = moves the point at which
the trigger stops - forwards, away from
the grip cheek
Front stop
Counter-clockwise = moves the point
from which the trigger-pull starts forwards,
away from the grip cheek
Clockwise = moves the point from which
the trigger-pull starts backwards, towards
the grip cheek
Magnet return strength
Counter-clockwise = makes magnet
return strength weaker.
Clockwise = makes magnet return
strength stronger
Activation point
Counter-clockwise = moves the point
at which the trigger will activate closer
to the end of the trigger pull
Clockwise = moves the point at which
the trigger will activate closer to the start
of the trigger pull.
Note: It is important not to over adjust the
back stop position set screw in this direction
as it will result in not enough travel for
a trigger pull to activate the button.
Note: It is important not to over adjust
the front stop position set screw in this
direction as it will result in not enough
return travel for the trigger to reset the
It is important not to over adjust this portion
of the trigger as it will negate the position
of the front stop set screw. For this reason
it is advisable that during the setup of the
trigger you should wind the magnetic return
strength adjuster screw counter-clockwise
several turns so that it does not interfere with
the adjustment of the front stop set screw.
Back stop Front stop
Magnetic return strength Activation point
24
READ ALL WARNINGS BEFORE ATTEMPTING ANY WORK ON YOUR ANGEL. SHOULD YOU BE UNSURE AT ANY STAGE YOU MUST SEEK EXPERT ADVICE.
Trigger removal
Firstly remove the grip frame.
See page 21 gs 1 - 4.
Then:
1 With the grip frame removed
you now have access to the
trigger clamp plate and the
trigger itself
2 Remove the trigger clamp plate
3 Remove the trigger
Important Note:
When reassembling the trigger
note the orientation of the trigger
clamp plate and ensure that the
clamp plate is located correctly
on the trigger bearings.
1
2
3
Trigger clamp plate
Locate onto
trigger bearings