User's Manual Part 1

Sensor Pad
6
5
4
3
1
2
2
3
1) Remove the mattress
from the crib.
2) Place the Sensor Pad –
Angelcare logo side up –
on top of the hardboard.
3) Run the connection pin,
warning label and the
first 5 cord covers down
along the backside of
the crib leg, between the
mattress support and the
inside edge of the crib.
4
5
4) Bring the first 4 cord
covers down the floor,
and keep the 5th cord
cover vertically, along
the backside of the
crib leg, between the
mattress and the inside
edge of the crib.
5) Remove any cord slack
to make sure no parts
of the cord are loose.
8 cm
6
6) Place the 6th cord
cover approximately
3 po (8 cm) from th e
edge of the mattress
support.
4132
CLICK!
7
7) Snap together the
remaining cord covers
that will run along the
floor.
4
3
2
1
8 9
8) Remove any cord slack
to make sure no parts
of the cord are loose.
9) Peel off the double-
sided tape on the 4
th
cord cover and place
it securely under the
crib leg.
10